Full Screen Instructions

To maximise viewing of the Sight Assembly section, press F11

Resume normal screen

To go back to "normal" screen size, press F11 again

Assembly Procedure

Please lay the component parts of the sight out in front of you, like the picture above. If you are assembling for a left handed bow, turn the picture through 180 degrees. Fasten Plate A to the outside edge of riser/handle using the two short screws. (The outside edge is the opposite edge from the arrow rest) Bar B is screwed to Plate A with Screw C. There are a number of horizontal positions to which the bar can be adjusted. Bar D has a graduated number scale. This needs to be the right way round, for ease of reading the numbers, once the sight has been assembled; the scale should face away from you when holding the bow in the shooting position. Also notice that two of the holes in Bar D have receiving nuts located in them. These particular holes need to line up with the vertical holes on Bar B. Once you have this alignment, secure Bar D to Bar B with the two Bolts, so that Bar D is beneath Bar B. The top picture on this page, shows a bow sight block set up for a right handed bow. If setting the sight block for a left handed bow, turn Block E round, so that the sight pin is facing in the opposite direction from the picture. The sight block—Block E—slides onto the top of Bar D. Slacken the long knurled screw, located to the side of sight block, to get the block onto Bar D. Gently tighten the same screw to secure the vertical position of the block.